32. Gender: Male. Hey guys. I was far away from ps3 jailbreak stuff for 3-4 years . So now , I decided to use my console again but i have some questions . (my cfw is Rebug 4.84.2 cobra) 1- After installing rebug toolbox and opening it , I saw my console temp in the up-right side of the screen : rsx : 72c. cpu : 70c. Your best bet would be to get a keyboard duster or "canned-air" as I call it, and blow in the back, front, and side vents of the PS3. This should dislodge most if not all the major dust inside the system. Keep a vacuum nearby to suck the large dust clumps that come out. Keep going around the sides until it doesn't blow dust from the other orifices. Step 6. Move the optical disk reader assembly to the left to expose one of the screws holding the power supply in. Remove the two Phillip #1 screws indicated and carefully disconnect the cable on the right side of the power supply. Lift the power supply straight up to remove it. The left side has a board connector underneath, so there will be Definitely disassemble and cleaning it out — PS3s seem like magic dust magnets, to the point that the fan blades themselves end up coated in the stuff. I normally start out picking up the thickest dust clumps with a paper towel moistened with rubbing alcohol, then switch to small paintbrushes dipped in rubbing alcohol to get in the crevices 6 days ago · To start the fan Test, disconnect the power cable of your PS3 Slim. Now, press the eject button on the front of the device and keep it pressed. Now, you can plug the power cord back in. The eject button keep it pressed. After a short time the fan should turn on for a Moment. You can release the eject button now. Install and deletion tests of the 12GB PS3, up against the 250GB upgrade, a 500GB Super Slim and a 128GB SSD. Despite slower read/write speeds, the 12GB model performs fairly well - until it comes MKG733 • 4 yr. ago. You can't remove scratches from plastic unless you can remove/lower the surrounding surface to the same depth of the scratch, which is very hard if it's the glossy plastic part it'll just look worse if anything abrasive is used. You could perhaps buy a replacement case or try one one of the sticker wraps. Download a clean PS3 system software copy onto a thumb drive; you do this first or at least have a thumb drive ready because you will need it later. Pull out your hard drive, install it on your computer as a drive, and do a full format of the drive in FAT32 format. VLkai.